STUDIO-CAPTURE Driver Ver.1.0.7 for macOS 12

Compatible with Apple Mac series (Intel-based).
Compatible with Apple Silicon Mac (using the M1 chip).

* Uninstall the old driver before you install the new driver. For details on the uninstallation procedure, refer to the Readme.htm file that was created when you extracted the archive.
* Since audio buffer settings are initialized after updating the driver, please setup the audio buffer settings in the driver again.
* When using two STUDIO-CAPTURE units connected to your Mac, set "VS EXPAND" of the second STUDIO-CAPTURE unit to "ON" and do not disconnect the USB cable from the Mac or the STUDIO-CAPTURE. If the STUDIO-CAPTURE cannot be used, restart the Mac OS.
* When the STUDIO-CAPTURE is connected to your Mac, operation on the STUDIO-CAPTURE panel will be disabled if no MIDI application is running on the Mac. If you want to operate the STUDIO-CAPTURE panel, start a MIDI application such as the STUDIO-CAPTURE CONTROL PANEL or a DAW software.

The downloaded file is an archive file. Information on how to use it is inside the Readme.htm file created after expanding the downloaded file.
Before installing the driver, be sure to read the Readme.htm(*) file.
* The information in Readme.htm might differ from what is on this page. For the most up-to-date information, refer to this page.

This driver has the following requirements.
* Please also check the System requirements for the audio/MIDI application and the operating system you're using.
Operating System
macOS Monterey (macOS 12)
Apple Mac series computer (Intel-based)
Apple Silicon Mac (using the M1 chip)
* Even if connected to a USB 3.0 port, the performance of the product will not change.
* Mac computers running Microsoft Windows are not supported.
* Apple, Mac and macOS are trademarks of Apple Inc., registered in the U.S. and other countries.
* All product names mentioned in this document are trademarks or registered trademarks of their respective owners.


Quick Links